Filter
Top Products
4 - 30
NGA 2000
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
HOME NO/NOx ZERO SPAN INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
Basic Controls
Measurement range number: 4
Range and functional control: LOCAL
Ranges with valid calibration: 4
Calibration status: READY
If it won´t calibrate...
Status: STANDBY
Ozonator status: On
Ozonator power: Enabled
Range upper limit: 250.0 ppm
Measurement mode: NOx
HOME ESCAPE INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
If it won´t calibrate...
gas concentration is what it is supposed to be.
If you have changed the range full scale value, or any
linearizer coefficients, or enabled or disabled it,
or done anything else that would affect how it
measures the gas, you may have made it hard for the
algorithm to get to a calibration.
until the readings are close to correct, and try again.
Check that you are flowing the correct gas, and the
Make sure that the reading is stable before starting.
In this case, manually adjust the coefficients
MEASURE STATUS NEXT LOCK INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
Main Menu
Basic controls...
Expert controls and set up...
Technical level configuration...
(Operational configuration)
(Diagnostic and manufacturing/service)
⇒ ⇒ Change to the
menu page "If it
won´t calibrate..."
Press
Notes:
• Follow the instructions
on the screen
to calibrate succesfully!
• If you have further
questions, contact
your customer service,
please!
⇒ ⇒ Change to the
main menu
Press
F1
Alternative:
If you want to continue with
further setups of the basic
controls, you can go back to
the corresponding menu with
the F2 key or the ←← -key.
⇒ ⇒ Change to the single
component display
Press
F1