Filter
Top Products
6 - 26
NGA 2000
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
Main Menu — Technical level configuration
↓↓
Diagnostic menus
↓↓
Control module diagnostics
↓↓
In the menu "Control Unit Diagnostics" you can find software error messages of the
control module. If such messages are available, you can act in the following way:
1) Make a note of the error messages.
2) Reset the message:
• Press the ENTER key or the →→ -key in the line "Edit to reset".
• Set up "Reset" with the ↑↑ -key or the ↓↓ -key and confirm it with the ENTER key:
The error messages will disappear if the reason is not existing any longer.
• If the error messages keep displayed:
3) System reset:
• Change to the menu "System Reset" with the F3 key (REBOOT).
• Press the ENTER key or the →→ -key in the line "System reset!" to reboot (see 6.1.5 p.
6-14).
4) Check the error messages:
• Go again to the menu "Control Unit Diagnostics".
• If the error messages are still existing, contact your customer service, please.
• If the error messages are disappeared, you should set up the report status again:
Set up "Report" in the line "Edit to reset".
HOME ESCAPE REBOOT INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
Control Unit Diagnostics
Software error code (1 = no error): 1
And:
And:
And:
And:
And:
And:
Edit to reset: Report
Last software error message
And:
6.3.1 Diagnostic Menus
Control Module Diagnostics