Filter
Top Products
System Calibration
90003749(1) [NGA-e (CLD-Software 2.3/MLT-Software 3.1.X)] 04/98 NGA 2000 Supplement - 15
The result of calibration for included AMs is displayed in an own menu page. This can be
achieved by softkey „RESULTS“ from different menu pages of SYSCAL.
SCMODULE
SCCONTROL
SCVALIDITY
SCRESULT1
SCRESULT2
Remember to run the calibration procedures as a test without actually to calibrate assert
parameter "Calibration Procedures in Test-Mode" to <Yes>.
It is also possible to switch for test purposes onto a specific gas of a specific module. This
possibility is located in menu "Test procedures".
SCTESTGAS
SCTIMEOUT
SCSTEPMOD
Calibration Results
Change analyzer module...
Analyzer module: CLD
Enabled for system-cal: No
Successful zero+span calibrated ranges: 1+2+4
Zero-Calibration failed on any analyzer module: No
Span-Calibration failed on any analyzer module: Yes
Expert controls and set up...
↓
System Calibration...
↓
Calibration/Test Procedures...
↓
Test procedures...
↓
Test Procedures
Gastest of specific module Sample-Gas
Timeout for gastest (0 = no timeout) 180 s
Choose specific analyzer module...
Analyzer-module: MLT/CH3