Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
94
Using the Pause for Low Ribbon option
Use this option as a definitive warning when running low on print ribbon. (Note: Select this
option so the Printer will beep and pause and the Media LED will flash when approximately
10 to 20 prints remain on the print ribbon.)
Step Description
1
Replace the ribbon and press the Pause/Resume button to continue printing
with a new ribbon.
OR
Leave the existing ribbon in Printer and press the Pause/Resume button.
• Select this option, then press the Pause/Resume button and the Printer
will continue printing until the end of the ribbon and will beep once before
each print job. (Note: It will not be necessary to press the Pause/Resume
button again to continue printing once it has been pressed initially during a
batch print.)
• Do not select this option and the Printer will still beep once before each
print job when approximately 10 to 20 prints remain on the print ribbon.
(Note: The Printer will not pause. Instead, it will continue printing until the
end of the ribbon, without user intervention.)