Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
23
Reviewing the TOP Line LCD Error/Status Messages (continued)
Message Cause Solution
Mag Verify Error The mag stripe was not encoded
properly.
See the Resolving the Mag Verify
Error Message procedure in
Section 2, page 46.
Mag Verifying Indicates data on mag stripe is
being verified.
No action required.
Print Cover Open The Top Cover is not properly
shut.
See the Resolving the Cover
Open Error Message in Section 2,
page 31.
Printer Ready Indicates Printer is ready to
print.
No action required.
Printing Indicates Printer is printing. No action required.
Rib Calib Failed The attempt at calibrating the
ribbon Sensor through the
Printer Driver has failed.
Be sure the ribbon is removed and
that the Printer's Top Cover is
closed. Try calibrating again.
Ribbon Error/Out The print ribbon is either out or a
ribbon error has occurred.
See the Resolving the Ribbon
Error/Out Error Message
procedure in Section 2, page 40.
Ribbon Jam/Out The print ribbon has become
jammed in the Printer rollers, is
stuck to the surface of the card
or is out.
See the Resolving the Ribbon
Breaking issues procedure in
Section 2, page 40.
Sensor Calibrate Indicates the Ribbon Sensor is
calibrating.
No action required.
Wrong Ribbon The wrong print ribbon is
installed.
See the Resolving the Wrong
Ribbon error (being displayed
incorrectly) procedure in Section
2, page 38.