Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
199
Removing and replacing the Idler Springs on the C11 Card Printer with the
Magnetic Encoder (continued)
Step Procedure
6 Follow these steps to install the new parts for the Idler Spring that is furthest
away from the Magnetic Encoder:
a. Install one (1) spacer (D810050) onto the Posts.
b. Install one (1) Roller (D810040).
c. Install one (1) Idler Spring (D830068) on top of the Roller.
d. Install two (2) screws (F000170) with two (2) washers (140040) onto each
Post.
Caution No. 1: Do not over-tighten the screws.
Caution No. 2: When installing the springs, ensure that the spring is
centered about the centerplate tabs, so that the tabs do not interfere with the
spring.
7 Replace the bottom access cover and fasten the two (2) screws.
8 Turn the Printer upright.
Continued on the next page