Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
190
Replacing the Card Feed Roller (D830058) – Left (continued)
Steps Procedure
15 Stand at the front of the Chassis Assembly; remove the Retaining Ring (140048)
from the Card Input Roller Shaft.
16 Remove the Transport Roller Gear.
(Note: The wide part of the gear hub faces the side plate.)
17 Remove the Washer Spring (130951).
(Note: The wave of the spring faces out.)
18 Remove the three screws (130938) from the Ribbon Drive Assembly.
19 Take the Ribbon Drive Assembly from the Printer.
20 Remove the Retaining Ring (140062) from the Card Input Roller Shaft.
21 Remove the two Drive Roller Bearings (760343) from the Card Input Roller.
22 Guide the Shaft forward and out of the rear Sideplate.
23 Angle the Card Input Roller up.
24 Slide the Shaft out of the front Sideplate.
25 Take the Card Input Roller out of the Printer.