Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
196
Removing and replacing the Idler Springs on the C11 Card Printers without the
Magnetic Encoder and for all C16 Card Printers (continued)
Step Procedure
5 Follow these steps to install the new parts:
a. Install two (2) spacers (D810050). (Note: Install one (1) spacer on each
set of posts.)
b. Install one (1) roller.
Caution: If there was a black Roller, ensure that the black Roller
was installed to the location closest to the input of the Printer.
c. Install one (1) Idler Spring (D830068) on top of each Roller (with the tabs
down).
Caution: When installing the springs, ensure that the Spring is
centered about the centerplate tabs. This ensures that the tabs do not
interfere with the spring.
d. Fasten four (4) screws (F000170) with four (4) washers (140040) into each
Post.
Caution: Do not over-tighten the screws.
6 Replace the bottom access cover and fasten the two (2) screws.
7 Turn the Printer upright.