Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
169
Replacing the Front Panel Board Assembly (A000265)
Refer to Drawings 830117, 830118 and 830119.
Estimated Repair Time: 20 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Open the Upper Imaging Assembly.
3 Remove the top two corner screws (130987) found just behind the top edge of
the Front Cover.
4 Close the Upper Imaging Assembly.
5 Remove the screw (130987) by the Card Exit Ramp.
6 Remove the Front Cover
7 Remove the five screws that hold the Front Panel Board in place
8 Open the Upper Imaging Assembly.
9 Loosen the top two corner screws (130987) found just behind the top edge of
the Rear Cover.
10 Close the Upper Imaging Assembly.
11 Remove the screw (130987) by the Card Exit Ramp.
12 Remove the Rear Cover.
13 Disconnect the cable from J2 and J24 on the Print Circuit Board.
14 Take the Front Panel Board Assembly from the Printer.