Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
78
C16 Print Driver Options
Using the Settings dialog box
Access the Settings dialog box via the Settings button on the Calibrate tab. Use the
adjustment mode to change the Printer's internal settings for overall Image Darkness, Image
Placement, Print Length and Magnetic Offset. (Note: The Card Printer is equipped with an
internal adjustment mode programmable through the Settings dialog box. This dialog box is
accessible only if the Printer is powered ON, in Ready Mode and is properly connected to the
PC.)
Step Procedure
1 Change these settings according to the original settings recorded on a label
attached to the Printer's base plate or rear panel or refer to the remainder of this
Section. (Note: These can be helpful to get back to the Printer's original
baseline settings.)
Caution! These settings are optimized at the factory and in most
cases, they will not need to be changed.