Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
31
Resolving the Cover Open Error Message
Symptom: The Printer errors immediately after sending a print job or the rollers do not
operate by pressing the cottons on the front panel (when the cover is open).
Step Procedure
1 Reseat the Cover Switch.
a. Open the top cover and remove the Print Ribbon.
b. Remove the two screws from the Cover Switch located near the ribbon take
up hub.
c. Reseat the switch on the Printer side plate and carefully replace the screws.
d. Ensure that the screws holding the Cover Sensor in place are not so tight as
to compress the inner components of the switch. (Note: The screws should
be tight enough to hold the switch in place snugly.)