Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
183
Replacing the Ribbon ID Sensor Board Assembly (820543) (continued)
Steps Procedures
13 Remove the Rear Cover.
14 Remove the two screws (130971) that secure the Print Circuit Board to the two
Standoff screws (140047).
15 Remove the screws that hold the Main Board Brackets in place.
16 Use the thumb and index fingers of both hands to carefully pry the Print Circuit
Board from the Power Circuit Board.
17 Disconnect the cable connection from J10 on the Print Circuit Board.
18 Take the Ribbon ID Sensor Board Assembly from the Printer.