Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
151
Cleaning the Card Feed and Cleaning Rollers
The Card Feed Rollers move the card throughout the print process. (Note: The Cleaning
Roller removes dust particles from a blank card as it feeds into the Printer. Clean these
rollers to prevent card jams and card contamination and ensure better print quality and
extended Printhead life.)
Step Procedure
1 a. Ensure a consistent Printer operation by cleaning these rollers approximately
every 250 prints or during every ribbon change, depending on the
cleanliness of the card stock and the environment (in which the Printer is
located).
b. Clean the rollers if the rollers appear dirty or if the cards start showing
speckles or debris on the printed surface by following Steps 2 to 7 (below).
2 Leave the Printer power ON and open the Printer's Top Cover.
3 Remove all cards from the Printer's Card Input Hopper.
4 Get a Cleaning Card from the Printer Cleaning Kit and remove its adhesive
backing paper.
5 Insert the Cleaning Card into the card output end of the Printer until the card
stops.
Caution: Be sure to insert the card so that the longest end of the card
is inserted first with the sticky side facing up.
Continued on the next page