Filter
Top Products
Publication No. GEG-99054 Genicom Mar 00
5-28 microLaser 210 User Guide
Warning Messages and Error Messages
Error Messages
The table below lists error messages, the possible causes of each error, and the actions required to
recover from each error.
Error Message
Line 1
Error Message
Line 2
Possible Cause Action
E2 JAM MISFEED
E3 JAM FUSER
E4 EXIT JAM
E6 JAM OFF. TRAY
E7 JAM DUPLEX
Remove Paper There is a paper jam
inside the printer.
Remove the jammed paper from
the indicated location.
Seethe“PaperJams”onpage
5-4 for information about
removing paper jams.
E5 COVER OPEN Close Top Cover The top cover is open. Close the top or rear cover.
E5 COVER OPEN Close Rear
Cover
The rear cover is open. Close the offset tray cover.
J3 TONER CART. Install/Reset The toner cartridge is
not installed, or an
incorrect cartridge is
installed.
Install the correct toner cartridge
according to the specifications.
See “Replacing the Toner
Cartridge” on page 4-3.
TRAY 1 MISSING Insert Tray Tray 1 is not in the
printer.
Insert the tray.
TRAY 2 MISSING Insert Tray Tray 2 is not in the
optional feeder.
Insert the tray.
TRAY 3 MISSING Insert Tray Tray 3 is not in the
optional feeder.
Insert the tray.
LOAD PAPER TRAY1 Paper Size/
Paper Type
Tray 1 is empty. Load paper into the tray.
LOAD PAPER TRAY2 Paper Size/
Paper Type
Tray 2 is empty. Load paper into the tray.
LOAD PAPER TRAY3 Paper Size/
Paper Type
Tray 3 is empty. Load paper into the tray.
LOAD PAPER FRONT Paper Size/
Paper Type
The front tray is empty. Load paper into the tray.
PAPER SIZE ERROR Paper Size/
Press Start
The paper size is not
supported by the
printer.
Check paper size specifications
andloadpaperthatmeets
specifications.
OUTPUT TRAY FULL Remove Paper The output tray is full. Remove paper from the tray.
OFFSET TRAY FULL Remove Paper The offset output tray is
full.
Remove paper from the tray.
PAPER PATH ERROR CloseFaceUp Thefaceuptrayis
open.
Close the face up tray.