Filter
Top Products
Mar 00 Genicom Publication No. GEG-99054
microLaser 210 User Guide 3-13
System Menu
System Menu
The system menu provides access to system settings. Use the following procedure to enter the sys-
tem menu:
1. Press the MENU buttononthecontrolpanel.
2. Press the NEXT button until the text “System Menu”isshownonthesecondlineofthedis-
play.
3. Press the SELECT button to enter the system menu.
4. Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, and Hex Print.
5. Press the SELECT button to enter a submenu.
6. Use the procedures in the following table to access and change the system settings:
Submenus Default Setting Available Settings Procedure for Changing Setting
Factory Defaults
Thissubmenuallowsyoutoreset
the printer to U.S. or Non-U.S.
factory defaults.
U.S. U.S.
Non-U.S.
1. Press NEXT or PREVIOUS to toggles
between U.S. and NON-U.S.
2. Press SELECT to choose and set
the factory defaults.
Display Language
Thissubmenuallowsyoutochange
thelanguageofthedisplay
messages.
English English
French
German
Italian
Spanish
1. Press NEXT or PREVIOUS to scroll
through the available languages:
English, French (Francais), German
(Deutsch), Italian (Italiano), or
Spanish (Espanol).
2. Press SELECT to choose and set
the language.
Power Saver
This submenu allows you to set the
number of minutes the printer is
idle before it reverts to Power
Saver Mode.
15 0 - 999 1. Press NEXT or PREVIOUS to
increase or decrease the number of
minutes.
2.PressSELECTtosavethissetting.
Wait Timeout
Thissubmenuallowsyouto
increase or decrease the length of
time (in seconds) that the printer
will remain in the waiting state—a
job is being processed, no
end-of-file has been detected, and
there is no more data to process.
This setting applies to both PCL
and PostScript print jobs.
20 0 - 99999 1. Press NEXT or PREVIOUS to
increase or decrease each digit of
the five-digit number.
2. Press SELECT set one digit and
move to the next digit.
3. Press SELECT after changing the
last digit to save this setting.
Job Timeout
Thissubmenuallowsyouto
increase or decrease the time limit
(in seconds) for PostScript jobs. A
0 setting indicates no timeout. This
setting applies only to PostScript
jobs.
0 0 - 99999 1. Press NEXT or PREVIOUS to
increase or decrease each digit of
the five-digit number.
2. Press SELECT set one digit and
move to the next digit.
3. Press SELECT after changing the
last digit to save this setting.