Filter
Top Products
Publication No. GEG-99054 Genicom Mar 00
10-10 microLaser 210 User Guide
Solving Face Up Tray Problems
Interpreting Face Up Tray Error Messages
The printer control panel displays error messages when there is a problem with the printer or any of
the optional paper-handling components. The following table lists all of the error messages associ-
atedwiththefaceuptray,thepossiblecauseoftheerror,andtheactiontotaketocorrecttheprob-
lem. If the control panel shows an error message that concerns another part of the printer, refer to
Chapter 5: Troubleshooting for a complete list of all warning and error messages.
Installation Problems
Simple oversights during installation may cause problems when you first use the face up tray. If the
face up tray is inoperative after you have installed it, use the following procedure to check several
possible causes.
1. Turn the printer off by pressing the [ O ] on the power switch on the right side of the printer.
2. Make sure that the face up tray is firmly attached to the printer.
If the face up tray is firmly attached but the face up tray is still inoperative, return to the
installation procedure and carefully repeat all of the installation steps.
3. Ifthefaceuptrayisstillinoperativeafterreinstallation,removeitfromtheprintersoyoucan
run tests on the printer alone.
4. Print a few sheets of paper to the main output tray to make sure the printer is still opera-
tional.
• If the printer is operational when the face up tray is not attached, contact either your sales
representative or a service technician and report your problem.
• If the printer is not operational when the face up tray is not attached, refer to Chapter 5:
Troubleshooting for procedures to correct printer problems. After correcting the printer
problem, return to this chapter to reinstall the face up tray.
◆ ◆ ◆
Error or Warning
Message Line 1
Error or Warning
MessageLine2
Possible Cause Action
PAPER PATH ERROR CloseFaceUp Thefaceuptrayis
open when it should be
closed.
Close the face up tray.