Filter
Top Products
Publication No. GEG-99054 Genicom Mar 00
8-4 microLaser 210 User Guide
Testing the Envelope Feeder
4. Remove the gear cover on the left side of the inside of the printer and store it in a safe place.
5. Push the envelope feeder all the way into the printer until it stops, making sure it is seated
firmly inside the printer.
Testing the Envelope Feeder
After installing the envelope feeder, use the following test procedure to verify that the feeder is oper-
ating correctly.
1. Turn the printer on by pressing the [ I ] on the power switch on the right side of the printer.
2. Once the printer has warmed up and displays the “Ready” message on the control panel dis-
play, use any software application to print a few sheets from the envelope feeder.
3. Ifthefeederdoesnotfeedpaperorifthecontrolpaneldisplaysanerrormessage,refer
to“Solving Envelope Feeder Problems” on page 7.
Selecting Print Media
Your printer can print on a variety of media, including plain paper, labels, transparencies, and enve-
lopes. Always use print media that meet the guidelines for use with this printer. Print media that is
not recommended for use with this printer may cause frequent paper jams or poor print quality.