Filter
Top Products
Chapter 5 157
Changing Your Computer Hardware Configuration
Memory Cards
Removing Memory
Perform the following steps to remove memory (DIMM cards) from your
system unit.
NOTE Lay the system on its right side (using the system unit’s front panel as a
reference) as shown in Figure 5-47. Note that before laying the system
unit on its side you should put it on a cushioned surface to avoid damage
to the system unit’s exterior.
1. Open the side panel of the system unit as explained in the section
“Opening the Left Side Panel of the System Unit” in this chapter.
2. Prop up the system unit power supply as explained in the section
“Propping Up the System Unit Power Supply” in this chapter.
Figure 5-47 Propping Up the Power Supply
3. Remove the fan from the hard disk drive chassis. See the section
“Removing the Fan from the Hard Disk Drive Area” in this chapter.
DIMM connector
Hard Disk
Drive Fan
Hard Disk
Drive Fan
Bracket
Power
Supply