Filter
Top Products
158 Chapter5
Changing Your Computer Hardware Configuration
Memory Cards
4. Press downward on the ejector tabs located on both sides of the
DIMM connector. See Figure Figure 5-48. This raises the DIMM card
for easy extraction.
Figure 5-48 Removing Memory Cards
5. Lift up evenly on the outside edges of the DIMM card to remove it.
See Figure 5-48.
6. Install the remaining DIMM cards in the correct order. See Figure
5-45.
7. Replace the hard disk drive fan as explained in the section “Replacing
the Hard Disk Drive Fan” in this chapter.
8. Replace the left side panel as explained in the section “Closing the
System Unit after Propping Up the Power Supply” in this chapter.
Plug the power cord back in to the electrical outlet.
9. Verify that this removal was successful by following the steps in
Chapter 6 of this book, “The Boot Console Interface.” Note that you
can also use SAM and select the Performance Monitor icon, then
the System Properties icon, and in the window that appears, select
the tab labeled Memory.
Notches
Ejector Tab