Filter
Top Products
9. Reconnect the interface cables and the power cord.
10. Turn the product on.
Check DIMM installation
After installing the DIMM, make sure that the installation was successful.
1. Turn the product on. Check that the Ready light is illuminated after the product has gone through
the startup sequence. If an error message appears, a DIMM might have been incorrectly installed.
See
Interpret control-panel messages on page 147.
2. Print a configuration page (see
Print the information and show-me-how pages on page 108).
3. Check the memory section on the configuration page and compare it to the configuration page that
was printed before the memory installation. If the amount of memory has not increased, the DIMM
might not be installed correctly, or the DIMM might be defective. Repeat the installation procedure.
If necessary, install a different DIMM.
NOTE: If you installed a product language (personality), check the "Installed Personalities and
Options" section on the configuration page. This area should list the new product language.
Save resources (permanent resources)
Utilities or jobs that you download to the product sometimes include resources (for example, fonts,
macros, or patterns). Resources that are internally marked as permanent remain in the product memory
until you turn the product off.
Use the following guidelines if you use the page description language (PDL) ability to mark resources
as permanent. For technical details, see an appropriate PDL reference for PCL or PS.
●
Mark resources as permanent only when it is absolutely necessary that they remain in memory
while the product is turned on.
●
Send permanent resources to the product only at the beginning of a print job and not while the
product is printing.
130 Chapter 9 Manage and maintain the product ENWW