Filter
Top Products
Item Sub-item Sub-item Values Description
RESET SECURITY YES
NO*
Specify whether the current security settings
on the print server will be saved or reset to
factory defaults.
DIAGNOSTICS EMBEDDED TESTS This menu provides tests to help diagnose
network hardware or TCP/IP network
connection problems.
Embedded tests help to identify whether a
network fault is internal or external to the
product. Use an embedded test to check
hardware and communication paths on the
print server. After you select and enable a test
and set the execution time, you must select
the EXECUTE option to initiate the test.
Depending on the execution time, a selected
test runs continuously until either the product
is turned off, or an error occurs and a
diagnostic page is printed.
LAN HW TEST YES
NO*
CAUTION: Running this embedded test will
erase your TCP/IP configuration.
Perform an internal loopback test, which
sends and receives packets only on the
internal network hardware. There are no
external transmissions on your network.
HTTP TEST YES
NO*
Check operation of HTTP by retrieving
predefined pages from the product, and test
the embedded Web server.
SNMP TEST YES
NO*
Check operation of SNMP communications
by accessing predefined SNMP objects on
the product.
DATA PATH TEST YES
NO*
Identify data path and corruption problems on
an HP postscript level 3 emulation product.
This test sends a predefined PS file to the
product. However, the test is paperless; the
file does not print.
SELECT ALL
TESTS
YES
NO*
Select all available embedded tests.
EXECUTION TIME
[M]
Specify the length of time (in minutes) that an
embedded test will run. You can select a
value from 0 to 24 minutes. If you select zero
(0), the test runs indefinitely until an error
occurs or the product is turned off.
Data gathered from the HTTP, SNMP, and
Data Path tests is printed after the tests have
completed.
EXECUTE YES
NO*
Select whether to initiate the selected tests.
34 Chapter 2 Control panel ENWW