Filter
Top Products
Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.
1. Press the Menu button
.
2. Open each of the following menus. Press the down arrow
to highlight it and then press the OK
button to select it.
a. CONFIGURE DEVICE
b. I/O
c. EMBEDDED JETDIRECT MENU
d. TCP/IP
e. IPV4 SETTINGS
f. CONFIG METHOD
g. MANUAL
h. MANUAL SETTINGS
i. IP ADDRESS, SUBNET MASK, or DEFAULT GATEWAY
3. Use the numeric keypad, or press the up arrow
or the down arrow to increase or decrease the
number for the first byte of the IP address, subnet mask, or default gateway.
4. Press the OK button to move to the next set of numbers, or press the back arrow
to move to the
previous set of numbers.
5. Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and then
press the OK button to save the setting.
6. Press the Menu button
to return to the Ready state.
68 Chapter 5 Connectivity ENWW