Filter
Top Products
hp officejet 7100 series
chapter 8
60
3 After the print carriage stops moving, release the gray print carriage latch
and then lift the print carriage to access the printheads.
4 Remove the old printhead by lifting the printhead handle and pulling
upward.
5 If there is plastic tape on the failed printhead, remove the plastic tape.
6 Push the failed printhead firmly down into the appropriate slot using the
printhead handle. Do not touch the printhead tower, and do not remove
the printhead handle.
Pull the printhead handle upward
GroPlusRG.book Page 60 Wednesday, October 16, 2002 1:16 PM