Filter
Top Products
hp officejet 7100 series
chapter 8
62
Caution! To avoid damaging the printer, remove a printhead only
when a replacement is available. If a printhead is removed
without being replaced:
– Close the print carriage and the print-carriage access door.
– Replace the printhead within 24 hours.
– Never remove an ink cartridge and a printhead at the same time.
3 Remove the old printhead by lifting the printhead handle and pulling
upward.
4 Remove the new printhead from its packaging and, being careful to touch
only the black plastic, gently remove the plastic tape.
Caution! Do not touch the copper contacts, the printhead tower,
or the ink nozzles.
removing the plastic tape from the printhead
5 Match the color on the top of the printhead to the color on the printhead
carriage.
6 Push the new printhead firmly down into the appropriate slot using the
printhead handle. Do not touch the printhead tower, and do not remove
the printhead handle.
Pull the printhead handle upward
Plastic tape
Printhead tower
Copper contacts
Ink nozzles
GroPlusRG.book Page 62 Wednesday, October 16, 2002 1:16 PM