Filter
Top Products
Introduction
7/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual
1-11
1.4 Menu Hierarchy
Menus for every task
For your convenience, menus are provided for configuration, calibration, maintenance, and I/O
setup tasks. The menu hierarchy is shown in Table 1-2. Not every menu item applies to every
system.
Table 1-2 9782 Conductivity/Resistivity Analyzer/Controller Menu Hierarchy
Menu Item Purpose Where
Described
CONFIGURATION
set up Analyzer/Controller to implement
your alarm and control strategy
Section 5
CAT/RETRANSMISSION configure parameters for using analog
outputs for control and retransmission of
process values
5.4
ALARMS specify value to be alarmed, alarm
setpoints, deadbands, and delay
5.6
DISCRETE CONTROL specify setpoints, range limits, etc. to use
relays for control
5.5
ADVANCED FEATURES set the clock, set up automatic cell
cleaning, and specify the computed value
to be displayed
5.7, 5.8, 5.9
CALIBRATION
calibration functions Section 8
CELL CAL FACTOR enter cell-specific cal factor 8.3
CALIBRATION TRIM calibrate system using a reference solution
with each cell; remove trim
8.4, 8.5
TDS CONVERSION FACTOR C1
TDS CONVERSION FACTOR C2
enter a process-specific total dissolved
solids conversion factor for each cell
8.6
Table 1-2 continued on next page