Filter
Top Products
I/O Setup and System Configuration
7/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual 5-5
ATTENTION
If you add an option card to the 9782, it is very important that you change the model number
stored in memory (see Section 10).
During I/O setup the software will display prompts only for those features the hardware can
support. The model number of the unit was stored in the 9782 memory at the factory. Each
combination of features has a unique model number (see Section 2). Therefore, the processor
can use this information to determine which prompts and selections are appropriate.
Entering the new number when you modify the hardware will let the processor know about the
new hardware capabilities. As a result, you will be able to configure the unit to take advantage of
features requiring that hardware.
Procedure
The procedure for I/O setup configuration is shown in Table 5-1.