Filter
Top Products
Introduction
7/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual
1-17
1.6 Overview of Installation and Setup Tasks
Setup tasks described in this manual
This manual contains instructions for all installation and operation tasks relating to the
Analyzer/Controller. (Instructions for installing and using the cells are provided in the manuals
supplied with the cells.) Table 1-3 provides an overview of the Analyzer/Controller installation
tasks, as well as providing references to the relevant sections of the manual.
Table 1-4 Overview of Analyzer/Controller Installation Tasks
Sequence Task Section
1
Consider the environmental and electrical specs when
selecting a site to install the Analyzer/Controller.
2
2
Unpack, inspect and mount the unit. 3
3
Check tag to confirm that unit is compatible with the voltage at
your site.
4
4
Install power wiring. 4
5
Perform I/O setup and configure the software to implement
your control strategy.
5
6
Wire inputs and outputs to match I/O setup in Step 5. 6
7
If AutoClean will be used, install necessary piping and valves. 7
8
Configure a tagname or other text string to be displayed at the
top of the screens showing real-time process values.
10
9
To limit access to I/O setup, configuration, calibration, and
maintenance functions, enter a password.
10
10
Display model number stored in memory and software version
number. Note these for future reference. (If you call for
technical assistance, you will need this information.)
10