Filter
Top Products
AutoClean Theory and Piping
7/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual 7-1
7. AutoClean Theory and Piping
7.1 Overview
Introduction
The AutoClean feature periodically rinses the cells automatically as described in this section. To
take advantage of this feature you must:
• Select it during I/O setup (see Section 5).
• Set the clock, and specify the frequency and duration of the rinse (see Section 5).
• Wire the relay assigned to this operation during I/O setup to operate the necessary valves.
(See Section 6 for relay wiring.)
• Install piping and valves as diagrammed in this section.
What’s in this section?
The topics in this section are listed below.
Topic See Page
7.1 Overview 7-1
7.2 AutoClean Sequence and Piping 7-2