Filter
Top Products
Submitting a Sterling Connect:Direct Process on a Remote Node 103
SNODENVIRN(remote-environment-name)
specifies the remote node environment.
PROCFILE(file-name)
specifies the name of the file or member that contains the Sterling Connect:Direct Process to be
submitted. This file must already exist on the node where the Sterling Connect:Direct Process is to be
submitted.
For information about parameters for the remote node, refer to the IBM Sterling Connect:Direct Processes Web
site at http://www.sterlingcommerce.com/documentation/processes/processhome.html
.
Optional Parameters
The following parameters are optional. Unless otherwise noted, the parameters apply to all remote node
environments.
CLASS(n|*MODED
)
determines the node-to-node session on which an operation can execute. The CLASS is a number
from 1–255. If you do not specify the CLASS parameter, it defaults to the number of maximum
sessions defined in the mode description for the communications environment.
*MODED uses the class value specified for the destination node.
CRC(*INITPARMS
|*NETMAP|*OFF|*ON)
Determines whether node and process statement overrides for Cyclic Redundancy Check (CRC) are
allowed. If this value is set to *OFF, setting overrides for CRC checking will be ignored. The default
value is *INITPARMS.
*INITPARMS
specifies that the CRC setting is determined by the value for the initialization
parameter TCP.CRC.
*NETMAP specifies that the CRC setting is determined by the value for the NETMAP parameter,
Cyclic Redundancy Check. The value for the initialization parameter TCP.CRC must be set to *ON
and the value for the initialization parameter TCP.CRC.OVERRIDE must be set to *YES.
*OFF specifies that CRC is disabled.
*ON specifies that CRC is enabled.
NEWNAME(file-name|*NONE
)
specifies a new name to be given to the submitted Process on the remote system. This name overrides
the name in the Process file.
file-name specifies the name for the submitted Process on the remote system.
*NONE
uses the name specified in the Process.
NOTIFY(*CURRENT
|*NONE|userid)
specifies the user ID on the receiving node to receive status messages that are directed to the message
queue of the user.
*CURRENT
uses the ID of the current user.
*NONE indicates that no user receives the messages.
userid specifies the name of the user to receive the status messages.
Note: The CLASS parameter is not used by Sterling Connect:Direct for i5/OS.