Filter
Top Products
Sending a File 37
When used with the FROM parameter, the access modes are W (primary read/write access), M
(primary multiple access), R (primary read only), RR (primary and remote read only access), WR
(primary read/write access; alternate read only access), MR (primary multiple access; alternate read
only access), and MW (primary multiple access; alternate read/write only access).
When used with the TO parameter, the access modes are W, M, and MW.
cuu specifies the virtual address of the disk where the CMS file is located. Any three-digit number is
valid.
TMSVGP(data-definition-name)
specifies the receiving file mass storage volume group that resides on a mass storage system (MSS)
device. This must be a valid DD (data definition) name.
TPROTCT(*YES|*NO
)
specifies whether an IBM RACF profile is created for a new file on a remote VM system.
TRACEOPT
Trace Instructions
(L, S, F, C, X, K, D, H, V, W, P,|*NONE|*ALL|*EXT| *COMMON|*INITPARMS|*CURRENT
specifies the trace bits that define functions to be traced by Sterling Connect:Direct for i5/OS. The
following are valid options:
L enables the main line logic trace for all components.
S enables the Process step logic trace.
F enables the file handler trace.
C enables the communications logic trace.
X enables the XDR trace.
K enables the KQV logic trace.
D enables the all-purpose data dump.
H enables the FMH dump.
V enables the XDR dump.
W enables the communications dump.
P enables the CIPC dump.
*NONE turns off all traces.
*ALL enables all product traces.(L, S, F, C, X, K, D, H, V, W and P)
*EXT enables all product traces plus two system traces (TRCICF and TRCJOB).
*COMMON enables the communications traces. (L, S, F, C, and H)
*INITPARMS indicates the traces specified in the initialization parameters.
*CURRENT selects the trace bits that the session manager is currently using.
Command Trace Options
L,S,F,C,X,K,D,H,V,P|*ALL|*EXT|*COMMON| *NONE)
specifies the trace bits that define functions to be traced for this command but not for the Process it
runs. The following are valid options:
L enables the main line logic trace for all components.
S enables the Process step logic trace.
F enables the file handler trace.
C enables the common logic trace.
X enables the XDR trace.