Filter
Top Products
116 Océ TDS800 User Manual
2 Click on the ‘Matrix composition' tab where the set of scanned originals is
displayed.
▼ Prepare the Matrix job
1
Fill in the 'User name' and 'Job name' fields ('User ID' and 'Account ID' are
optional).
Note: If your Océ TDS800 system has Océ Account Logging activated, then
the 'User ID' and 'Account ID' will be stored by Océ Account Logging.
2 Every original in the set that you scanned is assigned a name by Océ Matrix
Logic®.
■ To remove a specific original from the matrix job, highlight that original by
clicking on its name, and then click 'Remove'.
■ To remove all the originals from the matrix job, click 'Remove all'.
▼ Scan your Matrix Job originals
1
Open the 'Original' section on the scanner-operating panel.
2 Select 'Feeding' card.
3 Once the feeding card is open, use the 'Input mode' button to select 'Matrix
copy'.
Note: After you select Matrix copy, the 'File' and 'Print' sections as well as
the 'Legend location' and 'Drawing method' cards on the scanner panel are
disabled):
[62] Input mode with Matrix copy selected
4 Scan your entire set of originals (up to 100 originals), and remember to press
the green start button to close the set when you are done.
Add configurations
You can add predefined copy configurations to your Matrix Job. These
configurations are created in the ‘Copy configurations’ tab (see ‘Copy
configurations’ on page 119).