Filter
Top Products
60 Océ TDS800 User Manual
Specify the zoom factor
You can use the ‘Zoom’ setting to select a zoom factor.
▼ Selecting the zoom factor
1
Select the ‘Image’ card in the ‘Print’ section.
2 Select Automatic, 1:1, or set the zoom factor on the display of the operator
panel
■ Automatic zoom selection: the system automatically calculates the zoom
ratio based on the original size and the output media size
■ 1:1: Results in an image that is exactly the same size as the original.
■ Set the zoom factor on the display of the operator panel:
Use the ‘Arrow’ keys on the right of the display (see Figure 8 on page 45). If
you press one of the vertical keys, the zoom factor will increase or decrease
with steps of 0.1%. If you press one of the horizontal keys, the zoom factor
will increase or decrease with the steps predefined in the Océ Settings editor
by the key operator (see ‘Find system settings in the Settings Editor’ on
page 139).
Use the numeric keys at the bottom of the operator panel. You can specify
the exact zoom factor with 0.1% increments.
For example, if you want to specify a zoom factor of 25.4%, you type 254. If
you want to specify a zoom factor of 254%, you type 2540.
[19] Selecting the zoom factor
Note: You can also select the zoom factor from the ‘Custom’ section (if this
setting has been defined for this).