Filter
Top Products
52 Océ TDS800 User Manual
Job templates
A job template contains all settings for a job. Figure 9 on page 49 shows an
example with the following job templates.
■ Template 1
■ Template 2
■ Template 3
■ Template 4
■ Last used
The key operator defines the settings in the Océ Settings Editor on the Océ
Power Logic controller (see ‘Define the job templates’ on page 137). The key
operator can change the job template names, except for ‘Last used’, for
example into the following job names.
■ Single copy
■ Set copy
■ Matrix copy
■ Scan-to-file
■ Last used
When you select the ‘Last used’ job template, you recall all settings from the
previous job. You can change the settings or do the same job again. The ‘Last
used’ job template does not display when you turn on the scanner.
After you select a template, the sections display. The sections provide access
to the settings for the scanner input, the printer output and the scan-to-file
output (see ‘Sections on the display of the scanner operator panel’ on page 49).
Use the Custom Card here to provide access to frequently used settings
reffered to the type of job.
Change the operator panel language
It is possible to change the operator panel language. You can choose between
two preferred languages. Define the first and second language on the Océ
Settings Editor (see ‘Find system settings in the Settings Editor’ on page 139).
The Océ TDS800 supports a total of 16 languages. See Chapter 6, ‘Océ Power
Logic®: Settings Editor’ on page 125 and the On-line Help on the Océ Settings
Editor.