Filter
Top Products
Using the Océ TDS800 to Copy 45
Scanner operator panel
Press the green Start key on the scanner operator panel to start the original
transport on the scanner. To perform more complex copy jobs, change the
default settings on the scanner operator panel.
The scanner operator panel is located above the original feed. As you can see
in figure 8 on page 45. The panel consists of a display in the center surrounded
by a number of function, section and ‘Arrow’ keys. To the left of the display,
you can find the Stop and Job interrupt keys and below the display you can find
the Start, Numeric and Correction keys.
This section consists of two parts. The first part explains the basic use of the
keys. The second part deals with special use of the display. It describes how to
use the soft keys above and along the sides of the display to define your copy
settings.
.
[8] Scanner operator panel
1
2
3
4
5
6
7
8
9
12
13
14
10
9