Filter
Top Products
238 Océ TDS800 User Manual
3 Remove all tape between the rollers and knives (see Figure 162).
[162] Remove the tape
4 Insert a new trailing strip of tape between the rollers and the knives. For
complete information refer to ‘Change the tape roll in the reinforcement unit’
on page 196.
No reinforcement strips on the output without an error message
This error occurs when there are no reinforcement strips on the output although
reinforcement is selected. This can happen when the file header (Remote
Control Format or Océ Job Ticket) contains instructions to have no
reinforcement.
Note: If you want to process A4 formats, reinforcement can be disabled for this
format.
▼ To solve this error
1
Press the Stop key on the operator panel twice.
2 Open the side door of the Reinforcement unit.