Filter
Top Products
Introduction 27
▼ How to configure the automatic shut off and wake up timers
1
Use the shut off time-out setting in the Océ Settings Editor to define after how
many minutes of inactivity the printer and scanner turn off.
2 Use the ‘First working day’ and ‘Last working day’ settings in the Océ Settings
Editor to define on which days of the week the printer and scanner
automatically wake up.
3 Use the wake up ‘Time’ setting in the Océ Settings Editor to define the wake
up time of the scanner and the printer on working days.
▼ How to enable the automatic shut off and wake up timers on the printer and
scanner
1
Turn the key to the ‘off’ position. See figure 2 on page 23 and figure 3 on
page 23.
The Océ TDS800 turns off.
2 Turn the key to the ‘timer’ position. See figure 2 on page 23 and figure 3 on
page 23.
The Océ TDS800 turns on at the time and day defined in the Océ Settings
Editor.
Note: The timers must be enabled separately on both the scanner and the
printer.
Before you enable the timers, you must first turn the system off by turning the
key to the ‘Off’ position. When you then turn the key to the ‘timer’ position,
the system turns on. The system remains on during the defined time in the shut
off time out setting in the Océ Settings Editor. The system remains off until the
defined time in the wake up time setting in the Océ Settings Editor.
Note: The timer settings are stored local on the printer and the scanner. When
the controller is turned off, the timers still function as configured on the Océ
Settings Editor.
Before you enable the automatic shut off and wake-up timers, it is possible to
force the system to turn off.