Filter
Top Products
Media and supplies 191
▼ Use the roll loader to load a roll
1
Fully open the roll compartment.
In the drawer, the roll loaders are installed. The roll loaders consist of a metal
frame with a lever and a green knob in the middle of the lever.
2 Pull the horizontal lever to the right to put the roll loader in vertical position.
3 Pull the lever completely forward. The roll holder is lifted (see Figure 96).
[96] Roll loader in vertical position
4 Remove the roll holder from the paper roll compartment using both hands.
5 Press the green knob inside the roll holder to release the locking mechanism
and remove the core from the holder.
Note: You can place the new roll in the groove on top of the manual feed of
the printer. See the arrow on picture 91 on page 188.
6 Slide the roll holder in the new roll of material while you press the green knob.
7 Align the roll with the correct size indicator on the roll holder and release the
locking mechanism.
8 Use both hands to place the holder in the roll loader (see Figure 94).
9 Put the holder back in the roll compartment by returning the roll loader lever
to its vertical position.
10 Press the correct button inside the paper roll compartment and feed the paper
between the input guide plates as indicated by the arrow (see Figure 95). The
material is fed into the machine.
Note: Also see the stickers inside the roll compartments on how to feed
paper.
Attention: Be careful when you lift the lever to avoid damage to the roll
compartment.
11 Use both hands to slide the material under the metal paper guide until it makes
contact, follow the procedure ‘Load paper’ on page 188.
1
2