Filter
Top Products
97
Troubleshooting
The LINESPEED keyword must be set to 10 or 100
The LINESPEED keyword is used to force the network line speed to either
10 Mbps or 100 Mbps. If the keyword is not present the line speed is
automatically detected.
The loopback test failed
Before the driver finishes loading, it runs a loopback test. This tests
transmits a network packet internally testing all the transmit and receive
hardware before going online. This test also checks that the resources the
driver is using are valid. If the test fails it most likely means a hardware
failure or an incompatibility between the card and the CardBus bridge.
Adding keywords such as NOWRITEPOST, NOPREFETCH, and
NOBURST may fix the problem.
The PCI IRQ could not be verified, the driver may not function
This message only occurs if the PCIIRQ keyword has been used to force
PCI IRQ routing, and the IRQ keyword has been used to force a particular
interrupt. If the driver cannot set or verify the IRQ through the PCI BIOS,
it will give this message. If PCIIRQ is not present and the driver cannot set
or verify the IRQ through the PCI BIOS it will use ISA IRQ routing.
The RXBUFFERSIZE keyword must be between 1 and 30
The value of the RXBUFFERSIZE keyword specifies the number of
packets used in the receive buffer. Each packet requires approximately 1520
bytes of host memory.
The specified IRQ failed resource checking
The IRQ keyword was used to force a particular IRQ, but the resource
checking in the driver reported a failure. To override the resource checking
and load the driver anyway, use the NOCHECK keyword.
The selected memory is in use
The MEMORY keyword was used to force a particular memory address,
but the resource checking in the driver reported a failure.
To override the resource checking and load the driver anyway, use the
NOCHECK keyword.