Filter
Top Products
113
Troubleshooting
When using ODI for NetWare, I get attached to server, but can’t
see the F: login drive, “drive not ready” is the error message
you get when trying to login.
There are several reasons that this will happen, but the most common
reasons are:
• DoubleSpace defaults to G or H as lastdrive, thus H: or I: will be
the login drive when using DoubleSpace. The lastdrive command
in CONFIG.SYS seems to be overruled by DoubleSpace lastdrive.
Sample NET.CFG when using VLMs:
NetWare DOS Requester
FIRST NETWORK DRIVE = F
The following error occurred while loading protocol 0, error
58:...
This usually occurs when you have installed the IPX support stack in WFW
and ODI, and later decided to switch to NDIS2 and not use IPX as another
stack.
WFW sometimes will forget to remove the NWLINK.386 and
NWBLINK.386 from the transport line in the [386enh] section of your
C:\WINDOWS\SYSTEM.INI file. Fix this by making sure that the
transport line in that section reads:
[386ENH]
TRANSPORT=NETBEUI.386
Error 7323 or 3658:, The IFSHLP.SYS driver is not installed, or
Windows Network was not started, check your configuration.
Make sure the IFSHLP.SYS is installed in you CONFIG.SYS file and that
this file exists in the C:\WINDOWS directory. See the sample
CONFIG.SYS for proper syntax.
Error 7733: The protocol manager has reported an incomplete
binding.