Filter
Top Products
16
CHAPTER2
Installing NetWare Client 32 ODI Drivers under
Windows 95
When installing the PRO/100 CardBus adapter under Windows 95 you
have the option of installing either an NDIS3 driver (also known as
Miniport) or a 32-bit ODI client driver (Client 32).
Windows 95 installation instructions vary slightly for different versions of
Windows 95. See the instructions earlier in this manual on how to
determine your version of Windows 95, then follow the instructions below
for your version.
Installing under Windows 95 Version 4.00.950 or
4.00.950a
1 Follow the instructions earlier in this chapter on how to disable PC
Card support in Windows 95, under the heading Installing with
Microsoft Windows 95 Version 4.00.950 or 4.00.950a.
2 Follow the steps below for Client 32 installation under Windows 95
Version 4.00.950b. However, you may use any version of the Client
32 Install Software.
Installing under Windows 95 Version 4.00.950b or
later (OSR2)
NOTE
Windows 95 version 4.00.950b requires Client 32 for Windows 95 version 2.12 or
greater (ask your Network Administrator if you do not know which version of
NetWare Client 32 you have).
1 Follow the instructions earlier in this chapter for installing the Intel
PRO/100 CardBus adapter under Windows 95 version 4.00.950b. This
procedure will install the adapter with the NDIS3 (Miniport) driver.
2 Click the Start button in the left bottom corner of your Windows 95
Desktop and select Run. Then type the path to SETUP.EXE or
Browse to the Client 32 install directory. Possible paths are:
A:\
if installing from Disk 1 of the diskette version
C:\DIRECTORY_NAME\
if installing from a directory on your hard disk
\\NOVELL_SRV_NAME\SYS\PUBLIC\CLIENT\WIN95\IBM_ENU\