21
Software Installation
Installing with Windows 3.x and Windows for
Workgroups
To install under Windows 3.x or Windows for Workgroups, use the Intel
Installation Program. Insert the Installation Disk, into your disk drive, and
proceed as follows (substitute the correct drive letter for your system):
1 From the Program Manager, choose File, then Run. In the Command
Line box, type the following:
A:SETUP
2 Press Enter or click OK.
3 Select your network operating system from the list displayed and click
OK.
4 Follow the on-screen instructions. Note the following variations for
NetWare and other network operating systems:
Novell NetWare Installation
With Novell NetWare highlighted, click the OK button. Intel
provides all software necessary to configure your NetWare client
workstation. Upon completion, the Installation Program will reboot
your system. When your system comes back up, log in to the network.
NOTE:
The NetWare VLM shell is used to connect to your NetWare server. The Intel
Installation Program will decompress and configure the necessary files. If you
do not plan to use the Installation Program, see “Manual Installation” in the
alphabetical section of this chapter for instructions on how to decompress and
load the NetWare VLM files.
If you need NETX shell support, contact your System Administrator.
Installation of Other Network Operating Systems
For listed network operating systems other than Novell NetWare, highlight
your network operating system and click the OK button. The Intel
installation software will analyze your system and create a custom Intel
Network Drivers Disk. Make sure your diskette is not write-protected
when executing this step.
5 Once you have completed the steps prompted by the Intel Installation
Program, exit the program and find your network operating system in
this chapter of the User’s Guide, using the alphabetical listing under
the heading “Installing Network Software.” Follow the procedures
indicated there to complete the installation.