Filter
Top Products
104
CHAPTER 4
E If the problem persists, and you’re on a 10BASE-T network, try
patching directly into the hub. If the adapter works when plugged
directly into the hub, but not when attached via a longer cable run,
verify that the cable run length is within the IEEE 10BASE-T
specification (100 meters). If the cable length is correct, the
adapter may be defective. Contact Intel Customer Support.
Loopback failure reported when driver loads.
Add the MODE IO parameter to NET.CFG or MODE=IO to
PROTOCOL.INI.
Download the latest driver from our website or BBS.
Windows won’t load after installing adapter.
Try WIN /D:X. If windows loads this way, add the EMMExclude parameter
in your SYSTEM.INI file under the [386ENH] sction to exclude the
memory range used by the Intel adapter.
For example:
EMMEXCLUDE=D000-D3FF
Network Operating System Troubleshooting
Artisoft LANtastic
Driver loads but I cannot attach to any other workstations on the
network.
• Download the latest drivers from our website or BBS.
• Run the test utility to see if there is network traffic.
• Remove Card and Socket Services.
DEC PATHWORKS
This section only discusses the problems that might be related to
configuration of the Intel adapter. For non-Intel related issues, consult your
PATHWORKS user’s manual. These are the PATHWORKS error codes
(indicated by “percentage done”):
83 LOADING NDIS DRIVER...