Filter
Top Products
Printer Support—Chapter 5
205700 Series Color Mobile Computer User’s Manual
Opening the DTR Driver
The application opens the DTR driver by using the CreateFile() function.
The call can be implemented as follows:
hFile = CreateFile(_T(”DTR1:”), GENERIC_WRITE, 0, NULL,
OPEN_ALWAYS, FILE_ATTRIBUTE_NORMAL, NULL);
The first parameter “DTR1:” must reflect the device name and index used
in the RegisterDevice() function call.
The function call will fail for any of the following reasons:
S The port associated with the device during RegisterDevice() is currently
in use.
S The DTR device is already open.
S The share mode is not set to zero. The device cannot be shared.
S Access permissions are not set to GENERIC_WRITE.
Closing the DTR Driver
Using the CloseHandle() (hFile) fu nction closes the DTR driver. Where
hFile is the handle returned by the CreateFile() function call.
S TRUE indicates the devi ce is successfully closed.
S FALSE indicates an attempt to close a NULL HANDLE or an already
closed device.
Writing to the DTR Driver
You can u se the WriteFile() fu nction to send all Print data to the printer.
The print data being written must contain the proper formatting printer
commands.
DTR Printer Communications
All DTR printer communications should be based on the following flow:
1 Use CreateFile() to open the printer driver.
2 Use WriteFile() to write your data to the printer. Check for errors and
that all data were written.
3 Use CloseHandle() to close the driver.