Filter
Top Products
MESSAGES
● When the messages below are displayed:
When any of the messages below appear on the touch panel, take the action indicated.
Action PageMessage
The cover displayed is open. Close it/them securely.
__
“Close xxx cover.”
There is no paper in the drawer displayed. Load paper of size indicated.
31
“Add paper in drawer.”
One of the drawers is not closed properly. Pull it out, and push it back in
all the way.
The fixing unit is not set securely. Open the front cover and the left cover
and push the fixing unit securely into its original position.
33
185
“Set drawer.”
“Set the paper drawer.”
“Push Fixing unit until it stops”
The drawer currently in use is out of order and cannot be used for the
moment. Contact your service representative as soon as possible.
Continue copying using another drawer.
__
“Drawer inoperable.
Call for service.”
There is no paper of the appropriate size for the mode which has been
set. Check the paper.
__
“Check paper size.”
The orientations of the original(s) and the paper selected are different.
Change the orientation of the original(s). If the Start key is pressed without
changing the orientation of the original(s), same-size copying will be
performed.
38
“Reposition original or
change drawer.”
Original(s) has not been fed correctly during feeding into the DF. Remove
all originals and set them again.
38
“Reset all originals in feeder.”
An original is misfed inside of the DF. Remove the misfed original
following the procedure, remaining the main switch ON ( | ).
187
“Reset all originals in feeder.”
Two-sided copying cannot be performed on small size paper like 51/2" x
8
1/2" or custom size. Change the paper size.
53
“Cannot duplex copy on this size.”
Duplex unit has not been set correctly. Set it securely.
__
“Install duplex unit.”
Problem in the duplex unit. 2-sided copying is not possible. Contact your
service representative as soon as possible.
__
“Duplex tray inoperable,
call for service.”
There is not enough toner in the copier. Replace the toner cartridge
immediately as only one copy at a time can be made.
172
“Ready to copy.
Add toner to resume copying.”
There is not enough toner in the copier to make copies. Replace the toner
cartridge immediately.
172
“Add toner to resume copying.”
Open and close the front cover. If this message does not disappear, make
a note of the “C” and numbers appearing with it, turn the main switch OFF
(O), and contact your service representative.
__
“Call for service.”
166