Filter
Top Products
Miscellaneous Security Settings menu
Use To
Login Restrictions
Login failures
Failure time frame
Lockout time
Panel Login Timeout
Remote Login Timeout
Limit the number and time frames of failed login attempts from the printer control
panel before all users are locked out.
Notes:
• “Login failures” specifies the number of failed login attempts before users are
locked out. Settings range from 1–10 attempts. 3 attempts is the factory
default setting.
• “Failure time frame” specifies the time frame during which failed login
attempts can be made before users are locked out. Settings range from 1–60
minutes. 5 minutes is the factory default setting.
• “Lockout time” specifies how long users are locked out after exceeding the
login failures limit. Settings range from 1–60 minutes. 5 minutes is the factory
default setting. 1 indicates the printer does not impose a lockout time.
• “Panel Login Timeout” specifies how long the printer remains idle on the home
screen before automatically logging off the user. Settings range from 1–900
seconds. 30 seconds is the factory default setting.
• “Remote Login Timeout” specifies how long a remote interface remains idle
before automatically logging off the user. Settings range from 1–120 minutes.
10 minutes is the factory default setting.
Security Reset Jumper
Access controls=”No Security”
No Effect
Reset factory security defaults
Adjust the security settings.
Notes:
• “Access controls=’No Security’” retains all the security information that the
user has defined. “No Security" is the factory default setting.
• “No Effect” means the reset has no effect on the printer security
configuration.
• “Reset factory security defaults” deletes all security information that the user
has defined, and restores the factory default settings in the Miscellaneous
Security menu.
LDAP Certificate Verification
Demand
Try
Allow
Never
Allow the user to request a server certificate.
Notes:
• “Demand” means a server certificate is requested. If a bad certificate is
provided or if no certificate is provided, then the session is terminated
immediately. “Demand” is the factory default setting.
• “Try” means a server certificate is requested. If no certificate is provided, then
the session proceeds normally. If a bad certificate is provided, then the session
is terminated immediately.
• “Allow” means a server certificate is requested. If no certificate is provided,
then the session proceeds normally. If a bad certificate is provided, then it will
be ignored and the session proceeds normally.
• “Never” means no server certificate is requested.
Minimum PIN Length
1–16
Limit the digit length of the personal identification number (PIN).
Note: 4 is the is the factory default setting.
Understanding the printer menus 160