Filter
Top Products
Scan settings
Default setting: Primary resolution: Normal, Primary contrast: Normal, Scan
width: B4
Three different settings tell your machine how to scan documents. The initial fac-
tory settings are probably right for most applications, so try using them before
changing any of these settings:
• Primary resolution mode — Sets the resolution for your documents. Choose
either normal, fine, superfine (“S-Fine” on the
LCD
) or grayscale mode (“Gray”).
• Primary contrast mode — Sets how light or dark you want faxed documents
to be when they arrive at their destinations.
• Scan width — Sets the scan width for your documents. Choose either B4 or A4.
Note: These settings you choose effect your fax activity only.
To set these modes:
1
Press
MENU
,2,2,0,1,
ENTER
. The
LCD
shows:
2
To set the primary resolution mode, select “Primary Resolution” and then
press
ENTER
.The
LCD
will show:
3
Select resolution mode you want to set using the cursor key, then press
ENTER
.
4
To set the primary contrast mode, select “Primary Contrast” and then press
ENTER
. The
LCD
will show:
5
Select contrast mode you want to set using the cursor key, then press
ENTER
.
6
To set the primary scan width, select “Scan Width” and then press
ENTER
.
The
LCD
will show:
7
Select scan width you want to set using the cursor key, then press
ENTER
.
8
When you finished your choice, select “Exit” and then press
ENTER
to save
the settings.
By following the steps above, you’ve set your defaults for scanning. Before sending
documents, you can “override” these default scan settings for that transmission.
To override the default resolution and contrast settings before sending a document:
• Press [Mode] to change the resolution.
• Press [Contrast] to change the contrast.
Once your document is transmitted, your machine returns to its default settings.
Changing the default settings
4.1
Settings for transmission