Filter
Top Products
1.9
Getting started
Setting of the Paper Size
Default setting: Letter-sized paper
When you change the size of paper in the paper cassette, you must also change the
paper size setting, as shown below.
1
Press
MENU
,2,1,0,1,
ENTER
. The
LCD
shows:
2
To select the paper size in the 1st cassette, select “1st Cassette” using the
cursor key and then press
ENTER
. The
LCD
will show:
3
Use or to select the paper size, Letter , Legal or Half-letter , and
then press
ENTER
to save the setting.
4
To set the default paper size that is displayed when you set the paper on the
bypass tray, select “Bypass Tray” and then press
ENTER
. The
LCD
will show:
5
Using the cursor key, select the paper size, Letter , Legal , Half-letter or
OHP, and then press
ENTER
to save the setting.
Note: “OHP” appears only when the “Bypass Tray” is selected.
6
Select “Exit” and then press
ENTER
to exit this mode.
Loading paper in bypass tray
When you need to use a size of paper not currently loaded in your machine’s paper
cassette(s), or when you want to use a special type of paper (such as transparency
film), use the bypass tray.
1
Open the bypass tray on the right
side of your machine.
2
Pull out the hopper of the bypass
tray and raise the flapper release
lever.
3
Place the paper on the bypass
tray. Adjust the paper guide to fit
the paper and insert the paper
until it comes to a stop.
Then lower the flapper release
lever.
4
When you load the paper on the bypass tray, the
LCD
will show the primary
paper size you’ve set. (See “Setting of the paper size,” left column.)
5
Use the cursor key to select the paper size you set on the bypass tray.
Then press
ENTER
.
Note: If you use transparency film, select “OHP”.
Note: If you have set the Letter , Legal , Half-letter sized paper in the
bypass tray, the machine will use them when it runs out of the paper in the
paper cassette during the fax reception.