Filter
Top Products
Manage the Internet Settings Manually
53
AC1600 WiFi VDSL/ADSL Modem Router Model D6400
7. Enter the ADSL settings as described in the following table.
Field Description
Select Country Select the country in which you use the modem router.
Select Internet Service
Provider
Select the Internet service provider (ISP) that you are using.
If your ISP is not in the menu, select Other.
Transfer Mode For an ADSL connection, select AT
M.
DSL Mode Select the
ADSL mode that your ISP provided you:
• Auto. The
modem
router detects the DSL mode automatically. This is
the default setting.
• ADSL. Legacy version of
ADSL.
• ADSL2
. Legacy version of ADSL2.
• ADSL2+
. ADSL2+ provides the fastest downstream rates and can
interoperate with
ADSL2 and ADSL.
Enable This Interface Make sure that WAN1
is selected from the menu and that the Enable This
Interface check box is selected. These are the default settings.
Note: For information about interface WAN2, see Enable the WAN2
Interface for IPTV on page 197.
Multiplexing Method Select LLC-BASED
or VC-BASED, as indicated by your ISP.
The multiplexing method can either be virtual circuit (VC) based or logical
link control (LLC) based.
VPI Enter a number between 0 and 255 for the virtual circuit number for the
virtual path identifier (VPI), as indicated by your ISP
.
If your ISP did not provide you with a VPI setting, leave the default setting
(0).
The VPI might be required not only for a VC-based connection but also
for an LLC-based connection.
VCI Enter a number between 32 and 65535 for the virtual circuit number for the
virtual channel identifier (VCI), as indicated by your ISP
.
If your ISP did not provide you with a VCI setting, leave the default setting
(35).
The VCI might be required not only for a VC-based connection but
also for an LLC-based connection.
Use VLANID Select the
Use VLANID check box and enter the VLAN ID, as indicated by
your ISP
.
A VLAN ID might be required if you subscribe to both Internet service and
IPTV service. If your ISP did not provide you with a VLAN ID, leave the
Use
VLANID check box cleared, which is the default setting.
For information about setting up VLAN tag groups, see Set Up a Bridge for
a VLAN Tag Group on page 202.
Priority (802.1p) If your ISP provided you with a VLAN ID and a priority value, enter the
priority value, which is a number from 0 to7.
You can enter a priority value only in combination with a VLAN ID. If your
ISP did not provide you with a priority value, leave the default setting (0).