Filter
Top Products
Page 60 OmniTek XR User Guide, Software Release 2.3
Note: All of the look and feel choices here directly affect the waveforms displayed within
the Windows environment. They also affect waveforms displayed in Full Screen mode,
unless specific look and feel settings have been assigned to the chosen full screen view
as described on page 69.
Reset gain/gamma/decay
This gives you a single menu option to select to reset these aspects of the display to their
default values.
Split View
The ‘Split View’ controls allow you to split the waveform to simultaneously show an
unzoomed waveform and a zoomed waveform. The additional waveform can be
displayed either below the main waveform, or to the right, as determined by the ‘Split
Position’ control.
When the waveforms are split, the additional waveform display will mirror the original
waveform display. So if you have configured the unit to show Y+RGB, the extra section
will show Y+RGB. If you now use either the Region of Interest Window, or the right
mouse key, to select a portion of the main waveform, then the extra waveform display will
zoom in on the area you have just selected, while the original waveform will still show the
full display.
To return to the standard waveform display, unselect split view from the menu.
Note that the ‘split view’ item will have a check mark against it on the menu when the
function is activated.
Show Active Tooltips
Selecting Show active tooltips causes a small box to follow the mouse pointer
displaying the X and Y co-ordinates of the point under the pointer.
Save Snapshot
‘Save snapshot...’ takes the currently displayed waveform image, and writes it to disk as
a bitmap file. The user is prompted to enter a filename during the save operation.