Filter
Top Products
COMSPHERE 3900 Series Modems
5-4 November 1996 3910-A2-GN32-30
Table 5-1
(2 of 2)
Result Codes
Numbers
(1)
DescriptionWord
Numbers
(2)
26 15
CONNECT 7200/ EC***
Connection at 7200 bps with error control
27 5 CONNECT 1200/ EC* Connection at 1200 bps with error control
28 28 CONNECT 38400** Connection at 38,400 bps
29 14
CONNECT 19200/ EC**
Connection at 19,200 bps with error control
30 30 CONNECT 57600** Connection at 57,600 bps
77 77 FORBIDDEN Forbidden number
78 78 DELAYED Delayed number
* Only appears when the Extended Result Codes configuration option is enabled.
** Only appears when the Extended Result Codes configuration option is set for Use_DTE_Rate. This
displays the DTE data rate instead of the line rate.
*** Only appears when the Extended Result Codes configuration option is set for Add/EC. If this
configuration option is set for Add/V42, MNP, then either V42b, V42, MNP5, MNP4, MNP3, MNP2, or
NoEC appears.
AT Command List
AT commands are issued from an asynchronous DTE, such as a PC, and control the modem’s
operation and software configuration. AT commands are only applicable when the DTE Dialer
Type configuration option is set for AT. (Refer to the &Mn and &Qn commands.)
T
able 5-2 lists all A
T commands supported by the 391x Series modem. The first column lists the
A
T command. The second column defines and lists all possible values for that command.
The
Async Dial factory default is listed in bold.
The third column lists the key sequence used to enter
the equivalent DCP command. Use this to reference commands in Chapter 3 or Chapter 4 if further
description is necessary
.
AT Command Format
AT commands are entered in Command mode using the following format:
TYPE: AT Xn
Where: X
is the A
T command and n is the specific value for that command.
PRESS: Enter
In Table 5-2, the value for X
is listed in the A
T Command column and the value for n
is listed in
the Description column.